NOTICE: The dimensions shown on the attached dwgs for ball are the finished (after final machining) dimensions; your rough machined forging must guarantee these final dimensions.

注：附件球体图纸上的尺寸为机加工后的最终尺寸，你们的粗加工锻件必须保证这些最终尺寸。

The area and height of this deposition determine the ultimate ball size.

该淀积层的面积和高度决定了球的最终尺寸。

By measuring all dimensions associated with bearing, the shim dimension satisfying the requirements of bearing bore dimension was calculated to finally reach the requirements of assembly.

通过测量轴承各相关件的尺寸,计算出满足轴承内孔尺寸要求的垫片厚度,最终达到装配要求。

Eventually closed all the screw compressor assembly drawings, plans and dimensions of all the main components map.

最终形成全封闭螺杆压缩机总装配图、形尺寸图和各主零件图。

They impinge on the final structure, grain size and properties of this alloy.

他们对最终组织、晶粒尺寸和合金性能都有较大的影响。

A Study of Burr Fillister Sizes as well as the Minimum Fillet Radius of a Final Forging Die with the Finite Element Method

毛边槽尺寸与终锻模最小圆角半径的有限元法研究

largest permissible single chamfer dimension

允许最大单一倒角尺寸

"Maximum size datagram for reassembly by client; max 576

"客户重组的数据报最大尺寸；最大 576

Tie a cord around the waist and let it settle at the narrowest part. Take this measurement firmly

用卷尺围量腰部最细处。尺寸要量得紧些。

Place the tape around the fullest part of the hip. Use the hip bone (trochanter) as a guide. This measurement should be taken firmly.

用卷尺围臀围最丰满处。该尺寸要量得不松不紧。

not thin; of relatively great extent from one surface to the opposite usually in the smallest of the three solid dimensions.

不薄的；从一面到相对面尺寸相对大的，常指立方体中最小的尺寸。

doorway dimension

门开尺寸(ISO规定最小宽度为2200毫米

The maximum allowed size is XX bytes.

允许装入的最大尺寸为 XX 字节。

The minimum mesh size of the trawl cod-end in South China Sea

GB11780-1989南海区拖网网囊最小网目尺寸

The maximum size of an object has been exceeded.

超过了一个对象的最大尺寸。

Earth-moving machinery Minimum access dimension

GB/T17299-1998土方机械最小入口尺寸

reduced to the smallest possible size or amount or degree.

减到可能的最小尺寸、数量或者程度。

This packet be the maximum size allow by the post office .

这个包是邮局允许的最大尺寸。